Timer Control; Charging A Usb Device; Cleaning; Cleaning The Housing - Silvercrest TLGL 1000 B1 Bedienungsanleitung

Timer control

This battery charger has a timer control which automatically switches over to
retention charging after 17 hours . This serves as an additional protection against
overcharging should the charge termination not respond due to a possibly defec-
tive battery .

Charging a USB device

ImpORTANT
► Ensure that the power consumption of the USB device is not higher than
1000 mA . For more information, refer to the instruction manual of your
USB device .
♦ Insert the USB connector of the USB device into the USB output
battery charger .
♦ If necessary, switch the USB device on .
NOTICE
► You can simultaneously charge batteries in the battery charger and a USB
device at the USB output
ies is thereby halved and the charging process thus takes somewhat longer .

Cleaning

DANGER
► Always remove the plug before cleaning the device . There is the risk of an
electric shock! .
► When you are cleaning the device ensure that no moisture gets inside it, so
as to avoid irreparable damage to it .
ImpORTANT
► Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces .

Cleaning the housing

♦ Clean the surfaces of the device with a soft, dry cloth . For stubborn soiling
use a lightly moistened cloth .
♦ Never clean the insides of the charging slots with moist cloths . Instead, use
a clean soft brush to clean them .
♦ If soiled, clean the charging contacts with a dry cloth .
TLGL 1000 B1
. Be aware that the charging current for the batter-
3
of the
3
GB │ MT │ ■
37