NOTE
►
Between 1 and 7 batteries can be charged individually:
- 4 x type C or type D batteries in the charging slots 1 to 4
Li-ion battery (3 .6–3 .7 V) on the charging contacts
or
- 6 x type AA or AAA batteries in the charging slots 1 to 4
Li-ion battery (3 .6–3 .7 V) on the charging contacts
Charging Ni-MH/Ni-Cd batteries
♦
After you have connected the battery charger to mains power, you can now
insert Ni-MH/Ni-Cd batteries in charging slots 1 to 4
♦
The charging process starts automatically as soon as the batteries have
been inserted . The battery charger has an operating status display
each compartment in the charging slot . The operating status display of the
respective charging slots shows the current charge status of the individual
batteries . The display
in percent .
NOTE
►
If one of the operating status displays flashes red for longer than
5 seconds, the battery is improperly inserted or defective .
Charging Li-ion batteries
♦
After you have connected the battery charger to mains power, you can now
charge a Li-ion battery . Proceed as follows:
♦
Match the charging contacts
terminals on your Li-ion battery, by sliding the charging contacts
corresponding positions .
♦
Insert the Li-ion battery with its charging contacts lined up with the charging
contacts
CAUTION
►
Ensure that the charging contacts
negative terminals of your Li-ion battery . The polarity and voltage of the
rechargeable battery catwalk are recognised automatically by the battery
charger . Li-ion often have more than two contacts . Connecting the charging
contacts
battery .
TLGL 1000 B1
also shows the current charge level of the batteries
5
of the battery charger .
5
with the other contacts of your Li-ion battery could destroy your
5
5
5
to the positions of the positive and negative
are only in contact in the positive and
5
, plus 1 x
7
, plus 1 x
7
and charge them .
7
for
2
into the
5
GB │ MT
│
■
35