Calibration - CO/Tech FT-0205 Bedienungsanleitung

Snooze
• When the alarm sounds, press [ SNOOZE/LIGHT ] to temporarily mute the alarm
for 5 minutes. The alarm symbol will continue to flash.
• To silence the alarm permanently, press one of these buttons; [ CHANNEL/+ ] ,
[ MODE/SET ], [ MAX/MIN/ALARM ] or [ HISTORY/- ].

Calibration

• If the weather station sensors provide incorrect readings they can be adjusted.
In order to be able to calibrate the sensors precisely you will need to have
reference readings from sensors or instruments that you know provide you with
accurate readings.
• Relative humidity readings are always in the range of 10–99 %. The weather
station cannot be adjusted to accept readings outside this range.
1. Press [ CHANNEL/+ ] or [ HISTORY/- ] to increase or decrease the selected value
respectively. Holding in the button for 3 seconds will change the value quicker.
2. Press [ MAX/MIN/ALARM ] to reset the adjusted value to zero.
3. To finish the calibration and return to normal display mode, press [ SNOOZE/LIGHT ]
or wait for 30 seconds.
Temperature
1. In normal display mode, press and hold in [ MODE/SET ] and [ CHANNEL/+ ] at
the same time for about 5 seconds to enter the calibration mode. The indoor
temperature reading will start to flash.
2. Adjust the value to your reference value. The value can only be adjusted in
increments of 0.1 °C. Confirm using [ SET/MODE ].
3. The outdoor temperature reading will start to flash. Adjust the values in
the same way as in point 2.
Relative humidity
1. In normal display mode, press and hold in [ MODE/SET ] and [ HISTORY/- ] at
the same time for about 5 seconds to enter the calibration mode. The indoor
humidity reading will start to flash.
2. Adjust the value to your reference value. The value can be adjusted in increments
of 1 %. Confirm using [ SET/MODE ].
3. The outdoor humidity reading will start to flash. Adjust the values in the same way
as in point 2.
21