Agilent Technologies Turbo-V 1000HT Bedienungshandbuch Seite 292

17 Technical Information
Use
D
where: XXX = YES or NO.
This function is factory-set to YES.
D
Figure 37
292/310
When the last digit is entered, the display shows:
E L A Y
T H R E
Press the CYCLE NUMBER push-button and select YES if relay R2
must operate only after the run-up time or select NO when the R2
operation is needed right from stan of the turbopump and after
the rotational speed of the turbopump exceeds for the first time
the speed threshold value (see the preceding cycle diagram).
E L A Y
T H R E
Turbo-V 1000HT Controller User Manual / 87-900-894-01
E V E N
S H O L D
E V E N
S H O L D
A F T E
: X X
A F T E
: Y E S
R
X
R
(G)