Controller Controls, Indicators And Connectors - Agilent Technologies Turbo-V 1000HT Bedienungshandbuch

16 Instructions for Use
Use

Controller Controls, Indicators and Connectors

The following paragraph illustrates the Controller control panel and
interconnection panel. More details are contained in the appendix
"Technical Information".
Figure 2
1
2
3
4
5
230/310
Controller 969-9454,969-9554 front panel
Keyboard push-button for LOW SPEED mode selection. It is active only when the
front panel operation has been selected. Pressed once, the pump runs at about 2/3
of the nominal speed. To unselect the mode, press the push-button again.
Keyboard push-button for START, STOP, RESET mode selection. It is active only
when the front panel operation has been selected. By pressing once the starting
phase begins; if pressed again it stops the pump. If the pump has been stopped
automatically by a fault, this push-button must be pressed once to reset the
controller and a second time to restart the pump.
Keyboard push-button to recall on the display the cycle number, cycle time and
pumplife.
Keyboard push-button to recall on the display the pump current, pump temperature,
pump power and rotational speed. It is always active regardless of the operating
mode selected. Push-buttons 3 and 4, if pressed together for at least 2 seconds put
the controller in a routine where it is possible to program some operation
parameters.
LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
Turbo-V 1000HT Controller User Manual / 87-900-894-01 (G)