Vibration Isolator Installation - Agilent Technologies Turbo-V 81-T Bedienungshandbuch

17 Technical Information

Vibration Isolator Installation

Figure 28
Do not overtighten the valve as this may damage the thread on the pump.
CAUTION!
Then connect the cable from the valve to the suitable connector on
the controller.

Vibration Isolator Installation

Two vibration isolators for ISO and CFF inlet flange version pumps
are available as accesso-ries.
The two model part numbers are the following:
They typically reduce the vibration transmitted from the
Turbo-V 81-T to the system by a factor of 20.
Please refer to the relevant instruction manual.
214/228
model 969-9375 for ISO 63 flange;
model 969-9376 for CFF 4.5" flange.
Turbo-V 81-T User Manual / 87-900-984-01 (E)