Inhaltsverzeichnis
Werbung
en
Ventilation
The air at the back of the appliance will
heat up. This warm air must be allowed to
freely escape, otherwise the refrigerating
machine must perform more. This raises
electricity consumption. Hence, the
air inlet and outlet apertures should never
be covered or blocked off!
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to 220-240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A to 16 A fuse.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left hand side of the appliance. The power
cord may be replaced by a technician
only.
22
Switching on
the appliance
Rotate temperature selector, Fig. 2/1,
from controller position 0". The appliance
starts refrigerating. Interior light is
switched on when the door is open.
Selecting the temperature
We recommend storing perishable foods
at a temperature not warmer than +4 °C.
When the controller is at a medium
setting, the temperature drops to approx.
+4 °C in the coldest zone. Fig. 3
A higher setting results in a lower
temperature in the refrigerator and freezer
compartments.
We recommend:
S for short term storage of food:
low controller setting (energy saving
mode)
S for long term storage of food:
medium controller setting
S select a higher controller setting
set a high controller setting only
temporarily if: the door is opened
frequently, large quantities of food are
placed in the refrigerator compartment.
Werbung
Inhaltsverzeichnis
