Cleaning, Maintenance And Repair; Service Addresses; Service Intervals - NovoPress AXI102 Betriebsanleitung

AXI102 / AAP102
Pos : 48 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/Kapitel übeers chrift+Ü berschrift - T abelle @ 0\mod_1385652188500_18.doc x @ 1618 @ 2 @ 1
9.3 Meaning of the LED display
EN
LED display
Pos : 49 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/Alle_LEDs _aus- Kapitel 7.4 @ 1\mod_1448621701837_18.doc x @ 15723 @ @ 1
All LEDs off.
Pos : 50 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/Grüne_LED _l euc htet @ 0\mod_1400057953215_18.doc x @ 2330 @ @ 1
Green LED (2) lights up.
Pos : 51 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/Grüne_LED _blinkt @ 0\mod_1400062218616_18.doc x @ 2337 @ @ 1
Green LED (2) flashes.
Pos : 52 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/Grüne_LED s (4) @ 0\mod_1400077557059_18.doc x @ 2379 @ @ 1
Green LEDs (4)
Pos : 53 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/R ote_LED _bli nkt @ 3\mod_1489564282895_18.doc x @ 28653 @ @ 1
Red LED (3) flashes.
Pos : 54 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/R ote_LED _leuchtet @ 0\mod_1400062249067_18.doc x @ 2358 @ @ 1
Red LED (3) lights up.
Pos : 55 /RVT/Inbetri ebnahme und Betrieb/Bedeutung der LED- Anz eige/R ote-und_Grüne_LED _blinken_abwec hs elnd @ 0\mod_1400062253497_18.doc x @ 2365 @ @ 1
Red (3) and green (2)
LED flash alternately.
Pos : 56 /RVT/R einigung, Wartung, R eparatur /01a - Vorsic ht - Einsc halter- ACO102, ACO152, AC O202XL, ACO401, AXI/AAP102 @ 0\mod_1390815867244_18.doc x @ 1770 @ 1 @ 1

10 Cleaning, maintenance and repair

Pos : 57 /RVT/R einigung, Wartung, R eparatur /02 - Ser vic eans chrift - AC O102, AC O152, ACO/EC O202, ACO202XL, EC O301, AC O401, AFP/EF P202, AXI/AAP102 @ 5\mod_1563274700835_18.doc x @ 45254 @ @ 1

Service addresses

Novopress GmbH Pressen und Presswerkzeuge & Co. KG
Welserstr. 7
41468 Neuss
Germany
You can find the addresses of authorised specialist workshops by contacting Novopress or at
www.novopress.de.
Pos : 58 /RVT/R einigung, Wartung, R eparatur /03d - Informati on Wartung - AXI/AAP102 @ 0\mod_1403078178579_18.doc x @ 2790 @ @ 1

Service intervals

Service and repair work may only be carried out by Novopress or the authorised Novopress specialist
workshops.
Pos : 59 /RVT/R einigung, Wartung, R eparatur /04a - R egel mäßig 1.ter T eil - Bil d 14+ 15--AXI/AAP102 @ 0\mod_1403079596126_18.doc x @ 2797 @ @ 1
Status/cause
The device is switched off.
On standby.
Insufficient battery charge.
Battery charge display
Device not within the
temperature range
Device fault.
Service interval reached.
CAUTION!
Risk of injury during cleaning or repair work from inadvertently pressing
the On switch.
Therefore:
– Comply with the safety instructions and always remove the battery before
performing cleaning, servicing or repair work.
Information!
The next service deadline is indicated on the press device.
This service must be performed at least every 2 years or at the latest when the LED
display indicates that a service is due (see Section 9.3 Meaning of the LED display).
Measure
Briefly press the start button (1) (see
section 7.4).
Charge or replace battery.
The device only works within a
temperature range of -10 to +50°C. If the
red LED is flashing, the device must be
moved into a warmer or colder area. The
device can be warmed to operating
temperature by means of dry runs.
If the device is too warm it must be cooled
down by means of a short break.
Press the start button (1). If this is
unsuccessful, the press device is
defective.
Send the device to a specialist workshop.
NOTE!
The pressing operation may not have
been completed; please check and repeat
if required.
Take the press device to be serviced.
22