Start-Up And Operation Of Aap102 - NovoPress AXI102 Betriebsanleitung

AXI102 / AAP102
Pos : 44 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/Vor ber eiten komplett AAP102 @ 0\mod_1382620048811_18.doc x @ 1583 @ 12 @ 1
9

Start-up and operation of AAP102

EN
9.1 Preparing AAP102
1. The guide rod must be clean and greased.
If necessary, clean and lubricate the guide rod.
2. Press the pin into the bolt and keep it pressed (1). (Fig. 8).
Pull the bolt out completely (2).
Release the pin.
3. Push the pusher adapter with inscription 1 onto the guide rod in the direction of the arrow (Fig. 9).
4. Align the pusher adaptor with the guide rod such as to ensure that the transverse holes are on
the same axis (Fig. 10).
5. Lock the pusher adapter in place with the bolt (Fig. 10)
To do so:
Press the pin into the bolt and keep it pressed (1).
Push the bolt in fully (2).
Release the pin in the bolt.
6. Push the pusher adapter with the inscription 2 onto the guide rod in the direction of the arrow and
lock it using the bolt (Fig. 13)
7. Insert the battery.
Pos : 45 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
CAUTION!
Damage to pusher tool and pusher adaptors
Pressing operations using a system from a manufacturer for which the pusher tool and
pusher adaptors have not been designed may result in damage to the pusher tool and
pusher adaptors.
Therefore:
– Make sure that the system is press-fitted using the pusher tool and pusher
adapters from the system manufacturer.
CAUTION!
Damage to pusher tool and pusher adaptors if the bolt is not pushed in
correctly (Fig.11)
An incorrectly inserted bolt may result in damage to the pusher tool and pusher
adaptors.
Therefore:
– Make sure that bolts are fully inserted and locked in place.
CAUTION!
Damage to pusher tool and pusher adaptors (Fig.12)
The pusher tool and pusher adaptors can be damaged by
·
Fitting nominal widths that do not match
·
Pressing a system from a manufacturer for which the pusher tool and
pusher adaptors have not been designed.
Therefore:
– Make sure that adaptors have the same nominal width.
– Make sure that the matching nominal widths are lined up.
– Make sure that the system is press-fitted using the pusher tool and pusher
adapters from the system manufacturer.
20