Performing The Pressing Operation; Cleaning, Maintenance And Repair; Service Addresses; Service Intervals - NovoPress ACO102 Betriebsanleitung

ACO102
Red LED (3) lights up.
EN
Red and green LED (2)
flash alternately.

8.3 Performing the pressing operation

CAUTION!
Danger of crushing!
There is a risk that fingers and hands will be crushed.
Therefore:
– Keep body parts and foreign objects away from the press jaws during the pressing
operation.
– Do not hold the jaw levers with your hands during the pressing operation.
CAUTION!
Keep fingers away from the at-risk zone if no press jaw is fitted. (Fig. 4)
Fingers risk being crushed.
Therefore:
– Do not operate the device without the press jaws.
– Keep your fingers away from the at-risk zone.
Information
Always comply with the operating instructions for the press tools.
1. Check whether the nominal width of the press fitting corresponds to the nominal width of the press
jaws.
2. Observe the system manufacturer's instructions when fitting the press jaws. (Fig. 8)
Information
Make sure that the press jaw is fully closed when pressing is complete (Fig. 9)
3. To start the process, press the start button.
4. When the pressing operation has been completed
• Detach the press jaw from the press fitting (Fig. 10).
9

Cleaning, maintenance and repair

CAUTION!
Risk of injury during cleaning or repair work from inadvertently pressing the On
switch.
Therefore:
– Comply with the safety instructions and always remove the battery before performing
cleaning, servicing or repair work.

Service addresses

You can find the addresses of authorised specialist workshops on the "Service addresses" sheet provided
or at www.novopress.de.

Service intervals

Service and repair work may only be carried out by Novopress or the authorised Novopress specialist
workshops.
Device fault.
Service interval reached.
14
Press the start button (1). If this is
unsuccessful, the press device is defective.
Send the device to a specialist workshop.
NOTE
The pressing operation may not have been
completed; please check and repeat if
required.
Take the press device to be serviced.