Start-Up And Operation Of Axi102 - NovoPress AXI102 Betriebsanleitung

Information!
The batteries are not charged at the factory.
Therefore:
–
Information!
Limited temperature range for charging and storing the batteries.
Therefore:
–
Pos : 40 /RVT/Kurz bes chr eibung/Ger ät + Akku/längere Nichtbenutzung/AC O102, AC O152, ACO/EC O202, ACO202XL, AXI/AAP102 @ 0\mod_1382607497309_18.doc x @ 1524 @ @ 1
Feature of the press device after extended periods out of use or when changing the battery:
If the press device is out of use for approx. 30 minutes or the battery is reinserted, it switches off. No
LED is lit up any longer. Press the start button (1) briefly to start the press device.
Pos : 41 /RVT/Inbetri ebnahme und Betrieb/Ger ät vorberei ten/Vor ber eiten kompl ett AXI102 @ 0\mod_1382619745430_18.doc x @ 1577 @ 12 @ 1
8

Start-up and operation of AXI102

8.1 Preparing AXI102 (Fig. 6)
CAUTION!
Damage to the expander
Using expander heads from other system suppliers may result in damage to the
expander. The pitch of the expander cones differs from one system supplier to another.
Therefore:
–
–
Information!
For product number: 45200; 45222; 45250:
• Screw the expander head onto the expander and tighten by hand.
• Insert the battery.
Pos : 42 /RVT/Inbetri ebnahme und Betrieb/Ver press en/00b- Aufweiten kompl ett AXI102 @ 0\mod_1387198222391_18.doc x @ 1746 @ 2 @ 1
8.2 Expanding operation (Fig. 7)
CAUTION!
Danger of crushing!
There is a risk of crushed fingers and hands during the expanding process.
Therefore:
–
–
–
Information!
Before an expanding process, observe the system manufacturer's instructions.
1. Check that the nominal width of the pipe matches the nominal width of the expander head.
2. Check that the pipe and expander head are from the same system manufacturer.
3. Slide the pipe into the expander head as far as the stop.
4. Press the start button and hold it until the pipe has been expanded.
Pos : 43 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
Charge the batteries before using for the first time.
It is imperative that the operating instructions for the battery charger are complied
with.
Only use expander heads approved by the system supplier.
Only use expanders with intact, clean expander heads.
Grease the expander cone
Keep body parts and foreign objects away from the operating zone during the
expansion operation.
Do not perform dry runs without expanding a pipe.
Do not operate the device without the expander head.
19
AXI102 / AAP102
EN