System-Setup - Xoro HSD 8550 Bedienungsanleitung

SETUP
System Setup
Video
The setting component specify the kind of video output.
TV-RGB
This setting is useful, when you connect the DVD player with your TV set and the TV set has a
SCART connector which supports RGB signals. With RGB signals on SCART you can get a better
picture quality compare to FBAS signals (YUV setting).
INTERLACE-YUV
If you connect the DVD player with a 3-wire component cable to your TV set and can use only
Interlace mode (Y Cb Cr), than please choose the INTERLACE-YUV setting.
P-SCAN YPBPR
If you connect the DVD player with a 3-wire component cable to your TV set and can use
Progressive Scan mode (Y Pb Pr), than please choose the P-SCAN YPBPR setting.
S-VIDEO
If you connect the DVD player by S-VIDEO cable with your TV set, than uses the setting S-Video.
TV Type
Set the aspect ratio of the DVD Player according to the TV you have connected.
Normal/PS
If you have a normal TV and want both sides of the picture to
be trimmed or formatted to fit your TV screen.
Normal/LB
If you have a normal TV. In this case , a wide picture with
black bands on the upper and lower portions of the TV
screen will be displayed.
Wide
If you have a wide-screen TV.
Password
Move the cursor the PASSWORD item and press OK button to confirm and then input the secret
code "0 0 0 0" (if it is the first use). After confirmation, you are required to input new secret code and
then press OK button to confirm.
Warning:
Please remember the new secret code, otherwise you will not be able to change the parental
control. Please contact the agent or our company if you forget the secret code.
32
HSD 8550