Wall Mounting - Sanus VMF220 Bedienungsanleitung

2

Wall Mounting

2-1
Locate studs
2-2
Mark the wall
[03]
2-3
Drill pilot holes
2-4
Tighten lag bolts
[16]
002895.eps
MF220-Mount to wood stud
[17]
[03]
8
Wood stud mounting
< 16 mm
(5/8 in.)
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Verify the center of the stud using an awl. a thin nail, or an edge to
edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Ù
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
Ù
Level the wall plate [03] and mark the hole locations. NOTE: TV will
shift 82.6mm (3.25 in.)to the right when in the home position. Consider
this when selecting the location of your wall mount.
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To avoid
potential injuries or property damage
DO NOT over-tighten the lag bolts [17].
Ù
Tighten the lag bolts only until the washers [16] are pulled
Ù
firmly against the wall plate [03].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
82.6mm
3.25 in.
89 mm
(3.5 in.)
(6901-002023 <04>)
002895.eps
MF220-Mount to