Bosch PDA 180 Handbuch Seite 7

Tool Specifications
Delta Sander PDA 180
Part number 0 603 339 0.. 0 603 339 7..
Input power 180 W
Output power 80 W
No-load
speed (rpm) 9 200
No-load
oscillations (opm) 18 400
Sanding plate size 92 mm
Weight approx.
(without access.) 1.1 kg
Protection class
Use as Intended
The unit is intended for dry sanding and polishing of
wood, plastic, metal, filler and coated surfaces. It is
particularly suitable for working on profiles, in cor-
ners or hard-to-reach areas.
For Your Safety
Working safely with this machine is
possible only when the operating and
safety information are read com-
pletely and the instructions contained
therein are strictly followed. In addi-
tion, the general safety instructions in
the enclosed booklet must be fol-
lowed.
Before using for the first time, ask for
a practical demonstration.
If the cable is damaged or cut through
while working, do not touch the cable but
immediately pull the mains plug. Never
use the machine with a damaged cable.
The dust that is produced while working
can be detrimental to health, inflammable
or explosive. Suitable safety measures
are required.
Examples: Some dusts are regarded as
carcinogenic. Use suitable dust/chip ex-
traction and wear a dust respirator.
Dust from light alloys can burn or explode. Always
keep the workplace clean, as blends of materials are
particularly dangerous.
Do not work with materials containing asbestos.
Wear safety goggles.
Connect machines that are used in the open via a
residual current device (RCD) with an actuating
current of 30 mA maximum. Use only extension
cables that are approved for outdoor use.
GB
PDA 180 E
180 W
80 W
6 800 – 9 200
13 600 – 18 400
92 mm
1.1 kg
/ II / II
The machine can be used only for dry sanding.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from the
machine.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always switch off the machine and allow to come
to a stop before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation of
the machine if the original accessories intended
for it are used.
Initial Operation
Always use the correct supply voltage: The
power supply voltage must match the information
quoted on the tool identification plate. Tools with a
rating of 230 V can also be connected to a 220 V
supply.
Switching on and off
Switching on: Slide On/Off switch 3 forwards.
Switching off: Slide On/Off switch 3 backwards.
Selecting the Oscillation Rate
With the thumbwheel 4, the rate of oscilla-
5
tion can be selected (also during opera-
tion).
6
The optimum speed depends on the material and
should be determined by carrying out a practical
test.
Changing the Sanding Sheet
Attaching the Sanding Sheet
The sanding plate is covered with Velcro
material. The sanding sheet can there-
fore be quickly and simply attached with
Velcro fastening.
Knock the dust out of the Velcro material on the
sanding plate before applying the sanding sheet.
Fit the sanding sheet 9 flush to side of the sanding
plate and press it down. If the front point of the sand-
ing sheet is worn, simply remove the sheet, turn it by
120° and refit.
Accessories such as fleece or polishing felt are fas-
tened to the sanding plate in the same manner.
Removing the Sanding Sheet
Take hold of the sanding sheet 9 at one of the points
and pull off.
7