Step 4: Select Effect Speed; Step 5: Define Dimming Level - OSRAM LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
Press the jog wheel (2) to select this color and go to step 4, or long-press Zone C (3)
to abort programming. A short press of Zone C (3) gets you back to step 2.
11.5

Step 4: Select effect speed

This step defines the speed of the selected effect. In order to be able to change the
direction of the speed, negative values are be allowed (plus = to ascending DMX ad-
dresses, minus = to descending DMX addresses). The Scene buttons (1) are used to
select predefined values:
y Scene 1: -100% Speed
y Scene 2: -66% Speed
y Scene 3: -33% Speed
y Scene 4: 0 (fixed, Speed = 0)
y Scene 5: +25% Speed
y Scene 6: +50% Speed
y Scene 7: +75% Speed
y Scene 8: +100% Speed
You can also fine tune the effect speed with the jog wheel.
The jog wheel always reflects the current effect speed (CW = faster, CCW = slower).
Press the jog wheel (2) to select this effect speed and go to step 5, or long-press
Zone C (3) to abort programming. A short press of Zone C (3) gets you back to step
3.
11.6

Step 5: Define dimming level

Select the dimming state for the current settings. The bars of the Scenes (1) indicate
eight dimming states:
y Scene 1 ... 8: 10% ... 100%
You can fine-tune the dimming setting by using the Jog-Wheel (CW = increase bright-
ness, CCW = decrease brightness).
Press the jog wheel (2) to select this dimming state and go to step 6, or long-press
Zone C (3) to abort programming. A short press of Zone C gets you back to step 4.
20
2 1
3