Reset To Factory Defaults - OSRAM LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
The file VERSION.TXT on the LIGHTDRIVE+ has information about the firmware and
the MAC address. Drag-and-drop the new firmware file from your local system to the
drive representing the LIGHTDRIVE+. The LIGHTDRIVE+ checks if the firmware is
newer than the installed one and replaces the current firmware by the new version.
After the new firmware was installed, the LIGHTDRIVE+ deletes the firmware from its
internal drive and restarts to activate the new version.
15

Reset to factory defaults

To reset the LIGHTDRIVE+ to the delivery state, unplug the power supply. Keep the
jog wheel pressed and re-power the LIGHTDRIVE+. Keep the jog wheel pressed for
at least ten seconds and it will be reset to factory default values.
22