Step 1: Select Effect Block Size; Step 2: Select Color - OSRAM LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
least five seconds aborts the advanced programming. In every step, the connected
fixtures show the current state of the Scene, e. g. color, effect or brightness.
During advanced editing no time-out of this mode occurs, like changing Tone or
speed in standard mode. Either you execute the complete programming and save
the Scene, or you abort the programming with a long touch of the third Zone button.
11.2

Step 1: Select effect block size

The LED for Scene "1" is alight.
For the built-in effects, you can select a block size now. The block size is the number
of consecutive DMX addresses over which an effect runs. Use the Scene buttons (1)
to set the following block sizes:
y Scene 1: 1 Fixture
y Scene 2: 2 Fixtures
y Scene 3: 3 Fixtures
y Scene 4: 4 Fixtures
y Scene 5: 8 Fixtures
y Scene 6: 16 Fixtures
y Scene 7: 64 Fixtures
y Scene 8: 512 Fixtures (monochrome), 256 Fixtures (DW),
170 Fixtures (RGB), 128 Fixtures (RGBW)
You can use the jog wheel to set the block size to any value
in between. The block size is also shown on the connected fixtures. For example,
with a block size of three, the first three pixels are on, the next three pixels are off etc.
Press the jog wheel (2) to go to step 2, or long-press Zone C to return to standard
mode. A short press of Zone C (3) does not change anything, as there is no previ-
ous step.
11.3

Step 2: Select color

The LED for Scene 2 is alight, and all bars for all Scenes with color selections.
The Scene bars show available colors, depending on the selected fixture types, e. g.
DW or RGB. For monochrome fixtures only the brightness can be selected, for dy-
18
2 1
3