Connecting To Power - Z-EDGE Z3D Bedienungsanleitung

2.4 Powering the Dash Cam
Use only the supplied car charger to power the dash cam and charge the
built-in battery.
1. Plug the USB cable (13) on the
car mount into the car
dash cam's USB connector (7).
2. Plug one end of the USB
charging cable into the USB
Connector on the car mount (15).
3. Plug the other end into the car
charger, and insert that into
your vehicles lighter socket.
Automatic Power
• Once the vehicle's engine is switched on, the dash cam will automatically
power on.
• When the vehicle engine is switched off, the dash cam will automatically
save the recording and power off within 10 seconds.
Manual Power
• To manually turn the power on, press and hold
the 'Power' Button (1) for up to 3 seconds.
• To manually turn the power off, press and hold
the 'Power' Button (1) for 3 seconds.
WARNING:
If the environment reaches 115-degrees Fahrenheit or above, the car charger
may stop charging the dash cam battery. This is characteristic of a Lithium
Polymer battery and is not a malfunction.
-7-