Set Date & Time; Default Settings; Factory Reset - Z-EDGE Z3D Bedienungsanleitung

2.5 Set Date & Time
Before using the device, we recommend you set the correct date and time:
1. If the device is recording, short press the 'OK/REC' button (6) to stop and
enter Standby Mode.
2. Press the 'Esc/Menu' button (3) to enter the General Settings menu.
3. Press the 'Up' and 'Down' buttons (4 & 5) to select Date/Time and press
'OK/REC' button (6) to confirm.
4. Press the 'Up' and 'Down' buttons (4 & 5) to adjust the value and then press
'OK/REC' button (6) to confirm and move to the next field.
5. With all fields correct, press the 'OK/REC' button (6) to save and exit the menu.
WARNING:
Date/Time settings may automatically reset themselves if the battery is
allowed to completely drain. To ensure the correct time you must set the
time to your local time zone.

2.6 Default Settings

Default Settings
Resolution
Loop Recording
Motion Detect
Voice Setup
Date Stamp
G-Sensor sensitivity Normal

2.7 Factory Reset

To reset the dash cam to factory default settings long press the 'Power'
button (1) for 7 seconds.
1080P 30,1080P 30
3 mins
OFF
ON
ON
-8-
Button Beep
Language
Frequency
LCD auto Off
Auto Power Off
Parking monitoring
ON
English
60 Hz
3 Minutes
OFF
OFF