Motion Detection; Vibration Detection; Parking Monitoring; Taking A Snapshot - Z-EDGE Z3D Bedienungsanleitung

3.6 Motion Detection

With Motion Detection enabled, video recording is automatically started when
movement is detected by the camera lens. After approximately 10 seconds with
no movement detected, video recording is automatically paused.
Enable/disable feature: Feature Settings > Motion Detect

3.7 Vibration Detection

The Vibration Detection feature senses for unusual impacts or collisions
detected by the built-in G-Sensor. It automatically triggers the Emergency
Video Protection and Parking Mode features.
Set the sensitivity to automatically trigger these features with smaller or larger
vibrations (feature can also be turned Off): Feature Settings > G-Sensor
Sensitivity

3.8 Parking Monitoring

Enable Parking Monitoring for the dash cam to continue monitoring your
vehicle for unusual impact or collision when the engine is turned off and parked.
If a vibration is detected, the device will automatically turn on and begin
recording. Approximately 20 seconds after the motion or vibration is finished,
the device will automatically return to monitoring mode. All recordings are
automatically protected from being overwritten.
Enable/disable feature: Feature Settings > Parking Monitoring
Please note: When protection space (30% TF card capacity）is full,The protected
files will be overwritten with newly recorded protected files

3.9 Taking a Snapshot

1. If the device is recording, short press the 'OK/REC' button (6) to stop and
enter Standby Mode.
2. Short press the 'Up' button (4) to enter Photo Mode.
3. Press the 'Up' button (4) to take a snapshot.
3.10 Playback Videos & Photos
1. If the device is recording, short press the 'OK/REC' button (6) to stop and
enter Standby Mode.
2. Press the 'Down' button (5) to enter Playback Mode.
-12-