Power Supply; Remote Control - geo-FENNEL FL 110HA Bedienungsanleitung

POWER SUPPLY

Both Li-Ion rechargeable battery pack and
6 x AA alkaline batteries can be used.
6 x AA alkaline batteries
FL 110HA can be used with alkaline batteries.
The working time with new alkaline batteries is
approx. 40 hours.
Open screw (10) of the battery compartment (5)
by use of a coin.
Remove the Li-Ion battery pack.
Insert 6 x AA batteries into the separate batte-
ry housing and ensure that correct polarity is
observed.
Whilst use of alkaline batteries the recharging
function is disabled.
Li-Ion rechargeable battery pack
FL 110HA comes with Li-Ion rechargeable battery
pack. If the battery warning indicator (H) is flas-
hing the battery needs to be charged.
Connect the charger to socket (7) and the power
supply system.
The charging indication lamp (9) is indicating:
RED = batteries are being charged.
GREEN = charging procedure finished.
Recommended charging time: 10 hours. The charger can also be used as a power supply.

REMOTE CONTROL

1. Slope up / down
2. Slope on / off
3. TILT function
4. Shield of laser beam
5. ON/OFF switch
Battery case for
alkaline batteries
1
SLOPE up/down key
SLOPE key
2
SLOPE
3
TILT key
CALIBRATE
Direction key of
self-calibration
Figure 7: operation panel of remote control
Li-Ion rechargeable
battery case
10
+X -Y
Shield key
4
-X
+Y
Sleep key
5
TILT
Confirm key of
self-calibration
Adjust key of
self-calibration
EN
C
17