Setting The Temperature - Philips Supervapor GC6048 Bedienungsanleitung

ENGLISH
8
use distilled water, which you can obtain from your local supermarket
or chemist.
Do not put perfume, vinegar, starch or chemically descaled water in the
steam tank. Do not use water from a water softener.
C
4 Close the steam tank by firmly turning the screw cap
clockwise.
Fast refill
1 First set the 'steam tank on/off' switch (E) to 'off'.
C
2 Press the steam activator button (M) until you no longer hear
any steam escaping from the appliance.
3 Keep the steam activator button pressed in and slowly unscrew
the screw cap of the steam tank (B) by turning it anti-
clockwise.The steam tank will now be depressurised.
4 Remove the mains plug from the wall socket.
5 Fill the steam tank as described in section 'Filling the steam
tank' and let the appliance heat up again.

Setting the temperature

Always place the steam tank on a stable, level and horizontal surface
Do not put the steam tank on the soft part of the ironing board.
Always place the iron on the iron stand. Do not put the hot iron on
the supply hose or the mains cord. Make sure the cord does not come
into contact with the hot soleplate.
1 Put the mains plug in an earthed wall socket.
C
Push the 'Steam tank on/off' ≤ switch (E) to set it to position
2
I.The pilot light in the switch as well as the 'Steam tank heating
up' U pilot light (C) will go on.
The iron heats up faster than the steam tank and you can therefore
switch the iron on a few minutes after you have switched on the steam
tank.
C
3 Set the temperature control to the required ironing
temperature by turning it to the appropriate temperature
indication.
- Check the garment label for the required ironing temperature:
- 1
Synthetic fabrics (e.g. acrylic, viscose, polyamide, polyester)
- 1
Silk