English; General Description - Philips Supervapor GC6048 Bedienungsanleitung

ENGLISH

6

General description

A Steam tank
B Filling opening with screw cap
C Steam control
Position 1: minimum steam output
Position 5: maximum steam output (types
GC6044/GC6046/GC6048 only)
D 'Steam tank heating up' (U) pilot light.The pilot light goes out when
the appliance is ready for steam ironing.
E 'Steam tank on/off' (≤) switch with integrated pilot light
F 'Iron on/off' (≤) switch with integrated pilot light
G Manometer to verify steam pressure.When the needle is in the
green area, there is sufficient steam pressure (type GC6048 only).
H Mains cord
I Supply hose
J Iron storage hook with integrated hose storage clip
K 'Iron heating up' pilot light
L Jet-of-steam button (types GC6046/GC6048 only)
M Steam activator button
N Temperature dial
O Soleplate
P Removable iron stand
Q Button groove with jet-of-steam holes
R Anti-calc funnel (type GC6048 only)
S Cord storage facility
Important
For optimal safety, read these instructions carefully and look at the
illustrations before you start using the appliance.
- Do not put perfume, vinegar, descaling agents or other chemicals in
the steam tank.
- Never use the appliance if it is damaged in any way. Regularly check if
the mains cord and the supply hose are still undamaged and safe.
- If the mains cord of this appliance is damaged, it must always be
replaced by Philips or a service centre authorised by Philips, as
special tools and/or parts are required.
- Only use the screw cap of the steam tank that has been supplied
with the appliance, as this cap also functions as a safety valve.
- Check if the voltage indicated on the bottom of the steam tank
corresponds to the mains voltage in your home before you connect
the appliance.
- Only connect the appliance to an earthed wall socket.
- Never immerse the iron or the steam tank in water.
- Never leave the iron unattended when it is connected to the mains.
- When you have finished ironing and even when you leave the iron
for a short while, unplug the iron and put it on the iron stand.
- Always place the steam tank on a stable, level and horizontal surface.
Do not put the steam tank on the soft part of the ironing board.
- Always place the iron on the iron stand. Do not put the hot iron on
the supply hose or the mains cord.