Inhaltsverzeichnis
Werbung
The Connex Device is intended for use in the electromagnetic environment specified below. The customer or the user of
the Connex Device should assure that it is used in such an environment.
Immunity test
IEC 60601 test level
Electrostatic discharge
±8 kV contact
(ESD)
±15 kV air
IEC 61000-4-2
Electrical fast
±2 kV for power supply
transient/burst
lines
IEC 61000-4-4
±1 kV for input/output
lines
Surge
±0.5 kV, ±1 kV
IEC 61000-4-5
Line- to -line
±0.5 kV, ±1 kV, ±2 kV
Line-to-ground
Voltage dips, short
0 % U
; 0.5 cycle
T
interruptions and
voltage variations on
power supply input
At 0°, 45°, 90°, 135°,
lines
180°, 225°, 270° and
315°
IEC 61000-4-11
0 % U
; 1 cycle
T
70 % U
T
Single phase: at 0°
0 % U
; 250/300 cycle 0 %U
T
Power frequency (50/
30 A/m
60 Hz) magnetic field
IEC 61000-4-8
Note: U
is the a.c. mains voltage prior to application of the test level.
T
Electromagnetic immunity
Compliance level
±8 kV
±15 kV
±2 kV
±1 kV
±1 kV
±2 kV
0 % U
; 0.5 cycle
T
0 % U
; 1 cycle
T
; 25/30 cycles
70 % U
; 25/30 cycles
T
; 250/300 cycle
T
30 A/m
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment. If the user
of the Connex Device requires continued
operation during power mains interruptions, it
is recommended that the Connex Device be be
powered from an uninterruptible power supply
or a battery.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
English 3
Werbung
Inhaltsverzeichnis
