Before you start
Filling chemical tank
1.
Close liquid valve.
2.
Fill the tank with liquid chemical through the strainer (A). Do
not fill without strainer. (Dust in the tank may cause clogging
of the liquid line or pump)
3.
Stir up after filling to avoid chemical deposits at bottom of
tank.
4.
Secure the chemical tank cap.
The tank is calibrated by each liter up to 15 liters.
Strainer
Mark : Y2
Part number : E220-000020
Mesh size : 40
5.
On a piece of paper (50 mm × 90 mm), write the name of the
chemical to be used.
6.
Put the paper in the card case (B) to show the chemical the
tank contains.
10
NOTE