Security - CAME TS07 Bedienungsanleitung

Contents
PANEL PXC48
Going out
A
Full disarm
The control panel is ready but not inserted.
There are no alarms or errors.
06:13
Wednesday 01 March 2017
1

Security

The terminal can manage the basic functions of compatible security alarms .
By means of the terminal, you can fully or partially insert connected security alarm systems, silence
alarm devices, display the status of the areas, or access a list of events that caused the activation
or changed the status of the connected security alarm systems .
☞ To use the functions of the burglar alarm systems connected to the system, you must have
valid access codes.
The main page 1 shows 4 programmed scenarios which can be used to perform the main full or
partial system inserting/disarming immediately .
At the top left you can read the name assigned to the control unit displayed .
Staying at home Going to bed
INFORMATION
B
Home Back
The icons in column A show the system status .
At least one of the system's sensors (inputs) is open .
No input is open and the control unit is ready to be inserted .
At least one of the system's sensors (inputs) is excluded .
System not inserted .
System partially inserted .
System fully inserted .
GSM
No alarm in progress .
Alarm in progress .
Photo events The icon is replicated at the top right of all of the pages on the terminal; select to access the
security section directly .
Settings
No fault detected .
Fault detected .
Press the status icons to access the related pages and easily identify the source of alarms
☞
or faults.
After inserting, it shows that the exit time is running down .
An invalid access code has been entered .
The area B contains a list of information relating to the system status, connectivity and any
detected errors or alarms .
Depending on the type of system configuration, the following icons can also be displayed in this
area:
There are images which have been taken but not yet viewed . Tap the icon to show the images
or access the consultation page,
Connection to the active LAN network,
Connection to the active WiFi network,
GSM signal quality .