Programming An Energy Profile; Setting A Disconnection Order For Loads - CAME TS07 Bedienungsanleitung

Consumption less production: Energy profile ( - 1403 W )
Mon Tues Wed Thurs
Copy
Full scale
06:13
Wednesday 01 March 2017
3
Consumption less production: order of disconnection
Hair dryer
Oven
Dryer
Washing machine
06:13
Wednesday 01 March 2017
4
Fri Sat Sun
Paste
4.1 KW Hysteresis 0.4 KW
B C
Home Back
F E
Enable Disable
Enable Disable
Enable Disable
Enable Disable
Home Back

Programming an energy profile

The curve that is traced on the consumption/hours diagram makes it possible
to keep the total consumption of electricity below the pre-set values (load
disconnection thresholds axis) at set times of the day (hours of day axis) .
If necessary, controlled power loads are disconnected, in accordance with
Save
established priorities .
B Use the arrows (< >) to show the estimated instant power available; in this
specific case it can be calculated by adding the power delivered by the supplier
and the maximum power produced by the photovoltaic system .
C Use the (< >) arrows to show the variation in consumption tolerated compared
to the threshold set, below which the disconnected loads will be restored .
The curve must be traced taking into account the photovoltaic system that in the
hours of greatest sunlight supplies the maximum contribution of energy .
D Allows access to the list of controlled loads .
D
Loads config
Settings

Setting a disconnection order for loads

E With the help of the arrows (. ,), set the disconnection order you want;
the load at the head of the list will be the first to be disconnected, should the
threshold be exceeded .
F Enable/Disable a load from loads control; the disabled load will not be
disconnected .
Load on
Load off
Load disabled as threshold has been exceeded
Settings
Contents