CAME TS07 Bedienungsanleitung Seite 114

Contents
Network
MAC address 00:1C:B2:80:00:44
Mode
DHCP
IP address
Netmask
Gateway
06:13
Wednesday 01 March 2017
Network
A
Type of connection
Ethernet
Mode
DHCP
IP address
Netmask
Gateway
06:13
Wednesday 01 March 2017
Static
Save
Home Back
B
WiFi
C
Configure WiFi
Static
Save
Home Back
Network
☞ The screen shown in the figure appears on devices which do not have WiFi.
[Mode]
DHCP The IP address of the device is assigned by the DHCP server .
Static The IP address of the device is manually assigned .
[IP address]
If you have chosen to use a static IP, enter the device's IP address in this space .
The address must belong to the same subnet as the router and the other
connected devices; the default address is "192 .168 .0 .4" .
[Netmask]
Indicate the subnet mask (if different from the default setting) .
[Gateway]
Should it be necessary to route data traffic towards other subnets, you can
indicate a gateway in the relevant space .
Save the settings by tapping Save .
Press the [Back] button to go back to the list of parameters to set .
Settings
Network - WiFi devices
☞ The screens shown in the following figures only appear on devices which have WiFi.
If you connect to the network via the Ethernet port, tap button A and follow the network
configuration instructions in the previous paragraph .
If you connect to the network via WiFi, tap button B and then button C .
☞
The icon shows that WiFi connection mode is active.
Settings
(administrator password required)
(administrator password required)