Controls And Indicators - ELAC IW-S10EQ Handbuch

Controls and Indicators

1. RCA Line In — The line level connection is used to connect the subwoofer to your pre-amp/AV receiver.
2. Speaker Level In—This connection is used when your receiver does not have a SUB or analog outputs.
3. Subwoofer Speaker Output—This connection is used to connect to the included in-wall subwoofer.
4. Ethernet Connection— This connection is used to connect the amplifier to your home network for app control
and 3rd party controllers.
5. RS-232 —This connection is used to connect the amplifier to your 3rd party controllers. 12V Trigger—For use
with devices with 12V Triggers
6. AC Inlet — This inlet is a standard IEC power jack. Use the supplied power cord to connect the subwoofer to
an available AC outlet.
7. Primary Power Switch—This switch is used to turn on/off primary power to the amplifier
8. Power LED—This light will illuminate when the unit is powered on.
9. Link LED—The light will flash when communicating over ethernet or Bluetooth.
ELAC IW-S10EQ-W Subwoofer | www.elac.com | Page 4