Controls And Indicators - ELAC Muro Serie Bedienungsanleitung

Controls and Indicators

1. RCA Line In — The line level connection is used to connect the subwoofer to your pre-amp/AV receiver.
2. PAIR/RESET button — Used for pairing of the internal wireless audio receiver and factory reset of the
subwoofer:
-
press more than 3 sec. for paring until the LED is blinking fast, than release the button
The subwoofer is ready to be paired with the wireless transmitter.
- press more than 10 sec., for factory reset of the subwoofer. The LED will blink very fast.
3. Service — This connection is used for updating the subwoofer and not used for normal operation.
4. Status LED — Shows the status of the subwoofer:
-
dim LED on - indicates normal operation
- fast blinking LED - indicates wireless audio pairing mode
- slowly blinking LED - indicates the subwoofer is searching for a wireless transmitter
- very fast blinking LED - indicates factory reset
5. AC Inlet — This inlet is a standard IEC power jack. Use the supplied power cord to connect the subwoofer to
an available AC outlet.
2
1
5
ELAC SUB2010/SUB2020 Subwoofer | www.elac.com | Page 4
4
3
1
2
4
3
5