ELAC IW-S10EQ Handbuch Seite 11

Configure Network and other Settings
The IW-S10EQ subwoofer amplifiers default network setting is DHCP. You can assign the unit a static IP address
in the network section of the WEB GUI.
To access the WEBGUI please connect the unit to your home network via the Ethernet Jack on the rear of the
unit. Power on the amplifier and wait for it to boot up.
Download our iOS/Android "ELAC In Wall Sub Control" app on your phone or tablet and launch it. The app
should find the amplifier and display its IP address (Fig 1). Type this IP address into a browser on your computer.
If prompted, the default username and password are admin and admin. From the WEBGUI you can update
firmware, adjust network settings and default modes. (Fig 2 & 3)
ELAC IW-S10EQ-W Subwoofer | www.elac.com | Page 10