Seat; Seat Height - B+B Pyro Start Plus Bedienungsanleitung

PYRO START PLUS / SL
The arm supports for the side parts (desk/long) are fitted as desk
(short) on delivery.
• You can change the arm supports to the long setting in just a few
steps. First, remove the fixing screws on the underside. You can then
push the arm supports forwards and fix them again once they are
14 in the required position (see fig. 14).
• For the height adjustment of the armrests, first remove the fixing
screws (see fig. 14). The height can be adjusted in four stages by
using adapters. In the lowest setting (see fig. 15), all the adapters
are fixed under the support. The more adapters you attach above
the support, the higher the armrest is. In the highest setting, all the
adapters are above the support (see fig. 16).
15
16
17
| Lightweight wheelchair Lightweight wheelchair |

4.4. Seat

4.4.1 Seat height

You can adapt the seat height to your individual needs in just
a few steps.
1. Height of the driving wheel
There are 4 positions to allow the seat height to be adapted to the
user's requirements. For the lowest one, the castor bushing must be
turned and fitted on the other side.
Driving wheel and steering wheel must be in the same position in each
case. TOP – MIDDLE – BOTTOM
• Take the driving wheels off by using the floating axles.
• Loosen the screws at the adapter (Allen key, SW 4 and ring spanner
SW 10) and pull them out completely.
• Place the adapter at the required seat height.
• Insert the screws into the adapter again and tighten up the screws
again.
Place the steering wheel in the same hole position
as the drive axle. This is the only way to ensure
the directional stability of the wheelchair
Bischoff & Bischoff GmbH | 12.02.2020
PYRO START PLUS / SL
17
18