General Information; Hazard Statements; Notes - Grundfos CIM 500 Installations- Und Bedienungsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
These installation and operating instructions
describe the Grundfos CIM 500 Ethernet module.
Sections 1-3 provide the information necessary to be
able to install and start up the product in a safe way.
Sections 4-8 provide important information about
operating the product as well as information about
fault finding, technical data and disposal of the
product.
CONTENTS
1. General information
1.1 Hazard statements
1.2 Notes
2. Applications
2.1 Abbreviations
2.2 CIM 500 Ethernet module
3. Installation
3.1 Security
3.2 Connecting the Ethernet cable
3.3 Selection of Industrial Ethernet protocol
3.4 Setting up the IP addresses
3.5 Connection to the webserver
4. Status LEDs
5. Data activity and link LEDs
6. Fault finding
6.1 PROFINET IO
6.2 Modbus TCP or BACnet IP
6.3 EtherNet/IP
6.4 GRM IP
7. Technical data
7.1 PROFINET technical specifications
7.2 Modbus TCP technical specifications
7.3 BACnet IP technical specifications
7.4 EtherNet/IP technical specifications
8. Disposal
Read this document before installing the
product. Installation and operation must
comply with local regulations and accepted
codes of good practice.
4

1. General information

1.1 Hazard statements

The symbols and hazard statements below may
appear in Grundfos installation and operating
instructions, safety instructions and service
instructions.
DANGER
Indicates a hazardous situation which, if
not avoided, will result in death or serious
personal injury.
Page
WARNING
4
4
Indicates a hazardous situation which, if
4 not avoided, could result in death or
serious personal injury.
5
5
CAUTION
6
Indicates a hazardous situation which, if
6
not avoided, could result in minor or
6
moderate personal injury.
7
The hazard statements are structured in the
8
following way:
8
9
SIGNAL WORD
10
Description of hazard
11 Consequence of ignoring the warning.
- Action to avoid the hazard.
12
12

1.2 Notes

13
The symbols and notes below may appear in
14
Grundfos installation and operating instructions,
15
safety instructions and service instructions.
16
16
Observe these instructions for
17
explosion-proof products.
17
18
A blue or grey circle with a white graphical
18
symbol indicates that an action must be
taken.
A red or grey circle with a diagonal bar,
possibly with a black graphical symbol,
indicates that an action must not be taken
or must be stopped.
If these instructions are not observed, it
may result in malfunction or damage to the
equipment.
Tips and advice that make the work easier.