Technical Data; General Safety Information; Workplace Safety; Tool-Specific Safety Information For The Compressed Air Sandblaster - Parkside PDSP 1000 D4 Originalbetriebsanleitung

Technical data

Operating pressure: 6.3 bar
Air consumption: 320 l / min
Container volume: 0.9 l
Air quality required: purified and oil-free
Setting values
for work: set operating pressure on
the pressure regulator or fil-
ter pressure gauge max.
6.3 bar.
Noise emission value:
Measured sound value determined according to
EN 1265. The A-rated noise level of the air tool is
typically:
Sound pressure level: L
Uncertainty: K
Sound power level: L
Uncertainty: K
Wear ear protection!
Vibration emission value:
Total vibration value determined
according to EN ISO 20643: ah < 2.5 m / s
The vibration level specified
in these instructions was measured in accordance
with an EN ISO 20643 standardised measurement
process and can be used to compare tools. The
vibration emission value specified can also serve as
a preliminary assessment of the exposure. Different
uses of the air tool give rise to different vibration levels
and in many cases they may exceed the values
given in these instructions. It is easy to underestimate
the vibration load if the air tool is used regularly in
particular circumstances. If you wish to make an
accurate assessment of the vibration loads experi-
enced during a particular period of work, you should
also take into account the periods when the product
is switched off or is running but is not actually in
use. This can result in a much lower vibration load
over the whole of the period of working.
= 94 dB(A)
= 3 dB(A)
= 105 dB(A)
= 3 dB(A)
2
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the product is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety
information
Please read all safety informa-
tion and instructions. Failure to observe the safety
information and instructions may result in electric
shock, fire, and/or serous injuries.
KEEP ALL SAFETY INFORMATION AND
INSTRUCTIONS FOR FUTURE REFERENCE.

Workplace safety

a) Keep your work area clean and well lit.
Untidy or poorly lit work areas can result in acci-
dents.
b) Do not use the product in explosive
environments with flammable liquids,
gasses or dust. The product can create
sparks which can ignite dusts or fumes.
c) Keep children and other people away
from the product during use. You could
lose control of the product if you are distracted.
Tool-specific safety information
for the compressed air
sandblaster
Check the product for damage before use.
Refrain from using the product if it is defective.
Keep children and other people away from the
product during use. You could lose control of
the product if you are distracted.
RISK OF INJURY! IMPROPER USE!
Never point the product at people and/or
animals.
GB/IE/NI 7