Power and Data Transmission Unit
4
Mounting preparations
General mounting advice
The electronic components should be installed with utmost care since chafed or defective ca-
bles, damaged contacts etc. may seriously affect the safety of the system and cause its failure.
Ensure that all components are in faultless state before mounting them.
It is imperative to observe the attached assembly drawing!
4.1 Mounting the face plates
Attach SECUREconnect 100R and SECUREconnect 100F to the corresponding face plate,
each, using the special 4 x 7 Torx screws included in the bag (8 altogether).
Tighten screws with a max. torque of 1.0 Nm using a TORX T20 suitable tool only.
4.2 Mounting the contact holder with contact
plates
After having attached the face plate, mount the contact
holder with the 3 contacts to SECUREconnect 100R.
The 3 contact plates are firmly attached to the contact
holder, so all you have to do is press the unit through the
face plate bores into the provided jacks, you will feel the
part snap in lightly.
If necessary, the contact unit can be levered out again
carefully using an appropriate tool, e.g. an screw driver.
Contact holder with
contact plates
35