Abicor Binzel MIG/MAG ROBO Betriebsanleitung Seite 29

MIG/MAG ROBO welding torch
6.5 Connecting the control lead
a = Green
b = White
c = Brown
d = Yellow
e = Grey
f = Pink (insulated)
g = Blue (insulated)
h = Red
i = Black
j = Violet
Fig. 2 Connecting the control lead
The machine-side control lead is open. The customer must connect a suitable plug. If all data is
provided, the system will be supplied ready for connection. Otherwise, choose a compatible
plug for your power source and solder it to the corresponding leads according to the terminal
diagram.
6.6 Setting the shielding gas volume
NOTICE
• The type and amount of shielding gas used depend on the welding task and the gas
nozzle geometry.
• To prevent the shielding gas supply from becoming clogged by impurities, the cylinder
valve must be opened briefly before connecting the cylinder. This will expel any impurities
that may be present.
• Make all shielding gas connections gas-tight.
1 Connect the shielding gas cylinder to the wire feeder.
2 Set the gas quantity on the shielding gas cylinder's pressure reducer.
6.7 Introducing the wire
NOTICE
• Each time the wire is changed, make sure that the beginning of the wire is free of burrs.
1 Insert the wire into the wire feeder as specified by the manufacturer.
2 Press the "Zero current wire feed" trigger on the wire feeder.
BAL.0046 • 2019-02-07
EMERGENCY STOP
Zero-current
wire feed
6 Putting into operation
EN - 11