Important Notes; Notes On Operating Instructions; Intended Use - Mettler Toledo InPro 6850i Bedienungsanleitung

6
2

Important notes

2.1

Notes on operating instructions

These operating instructions contain all the informa-
tion needed for safe and proper use of the InPro 6850i /
6900i / 6950i sensor.
The operating instructions are intended for personnel
entrusted with the operation and maintenance of the
sensors. It is assumed that these persons are familiar
with the equipment in which the sensor is installed.
Warning notices and symbols
This instruction manual identifies safety instructions
and additional information by means of the following
symbols:
This symbol draws attention to safety instructions
and warnings of potential danger which, if neglect-
ed, could result in injury to persons and/or damage
to property.
This symbol identifies additional information and
instructions which, if neglected, could lead to
defects, inefficient operation and possible loss of
production.
2.2

Intended use

METTLER TOLEDO InPro 6850i / 6900i / 6950i sen-
sors are intended solely for inline measurement of
the oxygen partial pressure in liquids and gases,
as described in this instruction manual.
Any use of these sensors which differs from or ex-
ceeds the scope of use described in this instruction
manual will be regarded as inappropriate and incom-
patible with the intended purpose.
The manufacturer/supplier accepts no responsibility
whatsoever for any damage resulting from such
improper use. The risk is borne entirely by the user/
operator.
Other prerequisites for appropriate use include:
– compliance with the instructions, notes and
requirements set out in this instruction manual.
– acceptance of responsibility for regular inspection,
maintenance and functional testing of all associ-
ated components, also including compliance with
local operational and plant safety regulations.
– compliance with all information and warnings
given in the documentation relating to the products
used in conjunction with the sensor (housings,
transmitters, etc.).
– observance of all safety regulations governing the
equipment in which the sensor is installed.
InPro 6850i, 6900i, 6950i
52 206 349
InPro 6850i / 6900i / 6950i O Sensor 12 / 25 mm
2
© 02 / 09 Mettler-Toledo AG
Printed in Switzerland