Switching On And Off; Advice On Use; Sanding Surfaces; Replacing The Backing Plate - Parkside PDEXS 150 D3 Originalbetriebsanleitung

Switching on and off

NOTE
► Always switch on the air sander before
bringing it into contact with the workpiece
material .
Switching on the air sander:
♦ Press the operator's lever
♦ Set the speed using the speed control
Switching off the air sander:
♦ Release the operator's lever
♦ After you finish work, disconnect the device
from the compressed air source .
NOTE
► First disconnect the hose from the compressed
air source (compressor) and only then discon­
nect the compressed air supply hose from the
device . This will ensure that the compressed
air supply hose does not wave around in an
uncontrolled manner .

Advice on use

■ Wait until the device has come to a standstill
before you put it down .

Sanding surfaces

■ Switch the air sander on and bring the whole
of its sanding area into contact with the surface
to be abraded . Move it using even pressure to
and fro over the workpiece .
NOTE
► The sanding output and appearance are
largely dependent on the choice of sanding
sheet and the pressure applied . A sanding
sheet must be free of defects to produce a
good sanding output .
■ Ensure that you use an even pressure . Excessive
pressure does not produce a higher sanding
output, it just increases the wear on the sanding
sheet .
■ A sanding sheet previously used on metal must
not be used on other materials .
■ 20 │ GB │ MT
fully down
.
.

Replacing the backing plate

WARNING! RISK OF INJURY!
► Always disconnect the device from the com­
pressed air source before you replace the
backing plate .
♦ Push the open­ended spanner
backing plate and collar
♦ Release the backing plate
te anticlockwise and holding the open­ended
spanner still against this movement .
♦ Screw on a new backing plate
until tight while holding the open­ended spanner
still against this movement .

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro­
cesses) have accumulated on the appliance .
Avoid all skin contact with these substances .
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis . If
dust is produced or swirled up during mainte­
nance, it can be inhaled .
NOTE
To ensure correct functioning and long­term
durability of the sander, pay attention to the
following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning .
■ Check the speed and vibration levels after each
use .
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measurement
without any clamped tools . The idle speed may
not be exceeded under any circumstances at a
residual pressure of 6 .3 bar .
between the
.
by turning the pla­
clockwise
PDEXS 150 D3