Abicor Binzel ABITIG Little SL Betriebsanleitung Seite 20

4 Putting into operation
4.1 Equipping the torch
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
Equip the torch neck according to the following figure:
1 Torch body
2 Collet
Fig. 1
NOTICE
• It is also possible to use a gas diffuser instead of the electrode collet. Owing to its design,
it will produce a laminar gas flow.
4.2 Shortening the tungsten electrode
The electrode type is set by EN ISO 6848. The max. length of electrode depends on the type
of torch.
NOTICE
• The welding performance is affected by the selection of the tungsten electrode and by
wear. A smooth, groove-free sharpened end of the tungsten electrode has a positive effect
on the welding result.
EN - 8
1
2
Step 1
3 Back cap
4 Tungsten electrode
®
Torches ABITIG Little SL type 9/20, type 17/18/26
3 4
Step 2 Step 3
5
BAL.0285.0 • 2019-06-19
®
ABITIG Little SL
5
Gas nozzle