Specifications - Makita 9564P Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Lock-off lever
2-2. Switch lever
4-1. Wheel guard
4-2. Bearing box
4-3. Screw
5-1. Wheel guard
5-2. Bearing box
5-3. Screw
5-4. Lever

SPECIFICATIONS

Depressed center wheel diameter
Max. wheel thickness
Rated speed (n)/ No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-1. Screw
7-1. Lock nut
7-2. Depressed center grinding
wheel/Flap-disc
7-3. Inner flange
8-1. Lock nut wrench
8-2. Shaft lock
9-1. Lock nut
9-2. Abrasive disc
9-3. Rubber pad
Model
Spindle thread
)
0
Overall length
Net weight
Safety class
noise level determined
) : 85 dB(A)
pA
) : 96 dB(A)
WA
value (tri-axial vector
2
) : 9.5 m/s
h,AG
2
9564P
115 mm
2.3 kg
ENE048-1
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG900-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
sum)
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
11-1. Lock nut
11-2. Abrasive cut-off wheel/diamond
wheel
11-3. Inner flange
11-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
12-1. Wire cup brush
13-1. Wire wheel brush
14-1. Exhaust vent
14-2. Inhalation vent
9565P
125 mm
6.4 mm
M14
-1
12,000 min
307 mm
2.4 kg
/II
2
) : 2.5 m/s or less
h,DS
2
ENG902-1