Operation - LIVARNOLUX 14123305L Bedienungs- Und Sicherheitshinweise

Safety ... / Before Initial ... / Operation / Cleaning and maintenance / Disposal
Replace defective bulbs immediately. Before
replacing the bulb, always remove the mains
plug from the mains socket.
Allow the lamp to cool for at least 15 minutes
before replacing a defective bulb.
Do not allow any objects to cover the lamp.
Fire can result from the development of too
much heat.
Position the lamp so that it is protected from
moisture and dirt.
Never leave the light unattended whilst in oper-
ation. Excessive heat can result in a fire.
Only use the light bulb indicated.
Do not look directly into the light source (light
bulb, LED etc.).
This lamp is not suitable for use as a night light.
The lamp is not suitable for dimmers
or electronic switches.
Before Initial Use
Unscrew the threaded ring
clockwise.
Lift the lamp shade
(14123206L / 14123205L) .
Place the lamp shade
the correct way around.
Tighten the threaded ring
Use a clean, lint-free cloth to insert the lamp
Screw the lamp
1
Your light is now ready to use.

Operation

Using the lamp
Unwind the mains cable
use.
Insert the mains plug
Turn the light on and off with the ON / OFF
switch .
6
, turning counter-
2
off the socket
3 4
onto the socket
3
clockwise.
2
clockwise into the socket
completely before
5
into the socket.
7
Replacing a bulb
TRIC SHOCK!
Unplug the mains plug
Allow the lamp
before replacing.
Turn the defective light bulb
out of the bulb socket
Use a clean, fluff-free cloth when you are re-
placing a bulb.
Screw the light bulb
bulb socket
Plug the mains plug
Cleaning and maintenance
ELECTRIC SHOCK!
Before cleaning, always pull out the mains plug
out of the socket.
Do not use solvents such as petrol and the like
as they could damage the lamp.
For electrical safety reasons, never clean the
lamp with water or other fluids or immerse it in
4
water.
Only clean with a dry, lint-free cloth, a brush or
. a feather duster.
1
. Plug the mains plug
4
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
DANGER TO LIFE BY ELEC-
from the socket.
7
to cool down for 15 minutes
1
anti-clockwise
1
.
4
clockwise into the light
1
.
4
into the socket again.
7
DANGER TO LIFE FROM
into the socket again.
7
GB/IE/NI
7
7