Cleaning; Storage; Maintenance; Disposal And Recycling - Scheppach CJS254-20ProS Original Bedienungsanleitung

Setting the pendulum action
You can set the pendulum movement of the saw blade
(10) using the pendulum action switch (8). By having
no pendulum action (setting "0") you can produce
fine, clean cut edges. Turn off the pendulum action for
thin workpieces. With the pendulum action activated
(settings 1 – 3) you can cut through the workpiece at
increasingly quicker rates..
If possible always determine the optimum setting be-
forehand using a practical test.
Switching on:
• Push the ON / OFF switch (2) into position "I" and
ensure it engages.
Switching off:
• Press the rear part of the ON / OFF switch (2).
To ensure that the Li battery pack provides long ser-
vice you should take care to recharge it promptly. You
must recharge the battery pack when you notice that
the power of the cordless equipment drops.

9. Cleaning

DANGER!
Always pull out the battery pack before starting any
cleaning work.
Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device immedi-
ately each time you have finished using it.
• Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep into
the device. The ingress of water into an electric tool
increases the risk of an electric shock.

10. Storage

Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C. Store the electrical tool in its original packag-
ing. Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
20 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

11. Maintenance

There are no parts inside the equipment which re-
quire additional maintenance.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Saw blades, exhaust connection, car-
bon brushes
* Not necessarily included in the scope of delivery!

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
effective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.