Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL GE-US 18 Li Originalbetriebsanleitung

If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the power of the device drops. Never
allow the battery pack to become fully dischar-
ged. This will cause it to develop a defect.
5.3 Battery capacity indicator (Fig. 4)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs fl ash:
The battery pack has undergone exhaustive di-
scharge and is defective. Do not use or charge a
defective battery pack.

6. Operation

6.1 Recommended spreading settings (Fig.
5a/Item 1)
Each spreader material is supplied with inst-
ructions on how many grams per square meter
are to be spread. Set a low fl ow rate for smaller
quantities and increase the fl ow rate for larger
quantities.
The following settings are recommended:
Setting 1+2: Fine grass seeds
Setting 3+4: Light fertilizer
Setting 5+6: Heavy fertilizer
Setting 7+8: Pearled fertilizer or de-icer
Note:
Numerous variable factors (such as walking
speed, working height, motor speed etc.) do not
allow a specifi c recommendation of the spreading
setting. Rather, the optimal setting must be deter-
GB
mined by the user when starting with the work.
6.2 Spreading (Fig. 5a-5c)
Note:
The ON/OFF switch (2) activates the opening for
the spreader material (D) as well as the spreader
wheel (4).
Set the speed of the spreader wheel (4) with
the speed controller (6) (1= lowest / 6= highest
speed). Use the mechanical spreading width con-
troller (5) to infl uence the spreading width on the
left-hand side. Holding the universal spreader in
front of you so that the material can be spread un-
hindered, walk at a normal pace over the surface
over which you want to spread the material.
1. Ensure that the ON/OFF switch (2) is not acti-
vated and that the infi nitely adjustable speed
controller (6) is set to position „1".
2. Place the spreader on a paved surface and fi ll
spreading material into the spreading material
compartment (3).
3. Set the setting recommended for the relevant
spreading material using the spreading quan-
tity adjustment (1).
4. Set the required spreading width using the
speed controller (6) and the mechanical
spreading width controller (5).
5. Actuate the ON/OFF switch (2).
6. After carrying out work on a small area, adjust
the settings if necessary.
Note: If the slide of the spreader material opening
(Fig. 5b/Item D) gets jammed, press the On/Off
switch (Fig. 5a/Item 2) several times to unjam it.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Before putting away or cleaning, switch off the
equipment and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
- 18 -