Technical Data; Before Starting The Equipment - EINHELL GE-US 18 Li Originalbetriebsanleitung

4. Technical data

Operating voltage: .................................. 18 V DC
Max. area coverage: ................................. 800 m
Max spreading width: .................................... 5 m
Spreader material compartment volume: 3.3 liters
L sound power level: ..........................77 db (A)
WA
L sound pressure level: .......................66 db (A)
pA
Uncertainty K / K
WA pA
Vibration a : ..........................................≤ 2.5 m/s
h
Weight: ....................................................... 930 g
Important!
The equipment is supplied without batteries and
without a charger and is allowed to be used only
with the lithium-ion batteries of the Power-X-
Change series!
The lithium-ion batteries of the Power-X-Change
series are allowed to be charged only with the
Power-X charger.
The machine noise might exceed 85 dB (A). The
operator will require noise protection measures
if this is the case. The noise was measured in
accordance with EN ISO 11203 and EN ISO
3744:2010. The value of the vibrations emitted by
the handle was determined in accordance with
EN 60745-1.
Important!
The vibration value changes according to the
area of application of the electric equipment and
may exceed the specifi ed value in exceptional
circumstances.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
.............................. 3 dB (A)
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
2
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
2
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
4. Risk of eye damage if essential safety gogg-
les are not worn.

5. Before starting the equipment

The equipment is supplied without batteries
and without a charger.
5.1. Fitting the battery
Press the side pushlock button (c) of the battery
pack as shown in Fig. (2) and push the battery
pack into the mount provided. When the battery
is positioned as in Fig. 2, make sure that the
pushlock button latches in place! To remove the
battery pack, proceed in reverse order.
5.2 Charging the battery (Fig. 3)
1. Take the battery pack out of the equipment.
Do this by pressing the pushlock button.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the socket outlet. The green LED will then
begin to fl ash.
3. Insert the battery pack (11) into the battery
charger (10).
4. In the section entitled „Charger indicator" you
will fi nd a table with an explanation of the LED
indicator on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
- 17 -