Commissioning; Connecting; Inserting The Socket Wrench Or Bit; Adjusting The Compressed Air - Parkside PDSS 400 A1 Originalbetriebsanleitung

Safety instructions for air tools / Commissioning
In torque controlled machines
„ „
with continuous rotation the air
pressure has a safety-related
impact on the output. There-
fore hose length and diameter
requirements must be deter-
mined.
Never carry pneumatic tools
„ „
by the hose.
z Commissioning
Note: the device is operational after install-
ing the plug nipple
6
z Connecting
Note: only use connection hoses with a
minimum inside diameter of 9 mm.
First wrap a piece of Teflon tape (not in-
„ „
cluded) around the outer threads of the
plug nipple and the lubricator
6
Figure B).
Now screw the plug nipple
„ „
thread of the lubricator
You must use an open-end spanner (14
„ „
mm / 17 mm) to tighten this connection
with moderate force.
Now turn the combination of lubricator
„ „
and plug nipple
10
tion thread of the impact driver (see
2
Fig. C).
Also retighten this connection with an
„ „
open-end spanner (17 mm).
Now press the air hose onto the plug nip-
„ „
ple using a little force, until the hose
6
locks in.
16 GB
.
(see
10
into the
6
(see Figure C).
10
into the connec-
6
ATTENTION! Be sure the air hose is
firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two
screw connections between lubricator
, plug nipple
10
securely seated.
z Inserting the socket wrench
or bit
ATTENTION! Always install the desired
„ „
socket key before connecting the tool to
your compressed air system. Always dis-
connect the compressed air supply from
the compressed air connection
attaching or changing socket keys
Insert the correct socket
„ „
with extension
5
Slide the socket attachment
„ „
square 4 of the drive.
Be sure the snap ring is locked into the
„ „
notch of the socket attachment
Only use socket attachments sizes ½"
„ „
specified in figure A.
Be sure the socket attachments
„ „
are not damaged. Never use damaged
or the wrong size (not suitable) socket
attachments .
8
z Adjusting the compressed
air
Note: this device is designed for an operat-
ing pressure of up to 6.3 bar and a com-
pressor with the minimum air flow specified
in the technical specifications. When setting
the air pressure, remember the pressure
drops by approx. 0.6 bar with a hose length
of 10 m and an inside diameter of 9 mm.
and machine are
6
before
2
.
8
, if necessary
8
, in the drive .
4
onto the
8
.
8
used
8