Specifications - Makita DFL651F Bedienungsanleitung

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Star marking
5 Indicator lamps
6 Check button
7 Switch trigger
8 Reversing switch lever
9 Lamp

SPECIFICATIONS

Fastening torque
Square drive
No load speed *
Overall length
(Depending on the battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
• * No load speed is adjustable with exclusive application.
1
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
10 LED indicator
11 Screw
12 Ring
13 Clutch case
14 Scale
15 Hole for adjusting grip
16 Yellow line
17 Adjusting grip
18 USB cable
Model
Hard joint
Soft joint
1
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 / BL1840B /
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
BL1850 / BL1850B / BL1860B
ENE033-1
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping
GEA010-2
surfaces, when performing an operation where
the fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
19 USB port
20 Socket
21 Hole
22 Pin
23 Hook
24 Range of fastening capacity
25 Revolution angle (°)
26 Torque N•m
DFL651F
25 – 65 N•m
9.5 mm or 12.7 mm
80 – 200 min
–1
583 mm – 600 mm
2.5 – 2.9 kg
D.C. 18 V
GEB139-1