Handle Installation; Control Panel - Cavist CAVISTXV3 Gebrauchsanweisung

Handle installation

To install the door handle follow the below steps:
Open the door of the appliance and move the
1.
door gasket slightly to one side so that you can
see two designated holes for handle installation
Install the handle tightly as shown in the diagram
2.
above with the two screws provided.
Ensure the door gasket falls back into place and
3.
that the door opens and closes correctly.

Control panel

The control panel is situated in the middle of the appliances cavity and has a power, light,
temperature up and temperature down touch controls, these are explained below:
Power on/off – press to turn the appliance on and off
1.
Light on/off – press to turn the internal light of the appliance on and off
2.
Temperature display – displays the internal temperature of the appliance in Celsius or
3.
Fahrenheit
Temperature up – press to increase the internal temperature of the appliance
4.
Temperature down – press to decrease the internal temperature of the appliance
5.
Allow to stand for a minimum of 3 hours before plugging in to the mains
During first use
Important: When you use the wine cooler for the first time or restart the appliance after it has been
turned off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the display. This is normal and it is due to the length of activation
time. Once the wine cabinet has been running for a few hours everything will be back to normal.
When you first switch on the appliance, the compressor will run continuously until the wine cabinet
reaches a cool enough temperature.
During this period of time, you should try not to open the door frequently or place bottles inside
of the appliance
If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the
appliance or reconnecting it to your mains supply.