Handle Installation - Cavist CAVIST91 Gebrauchsanweisung

HANDLE INSTALLATION

To install the door handle follow the below steps:
1. Open the door of the appliance and move the door gasket
slightly to one side so that you can see two designated holes for
handle installation
2. Install the handle tightly as shown in the diagram above with
the two screws provided.
3. Ensure the door gasket falls back into place and that the door
opens and closes correctly.
USING YOUR WINE COOLER
Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information
contained in the installation instructions.
o After delivery, wait for eight hours before connecting the appliance to your mains supply. This will
allow any refrigerant gasses that may have been disturbed during the transportation process to
settle.
o The outside of the appliance and the removable accessories contained within it, should be
cleaned with a solution of liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved in
lukewarm water. The interior and accessories should be thoroughly dried, after the cleaning process
has been completed.
o There can be an odour when you first switch on the appliance. It will lessen as the appliance starts
to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has
been turned off for a long time, there could be a few degrees variance between the temperature
you select and the one indicated on the LED display. This is normal and it is due to the length of
activation time. Once the wine cooler has been running for a few hours everything will be back to
normal.
o When you first switch on the appliance, the compressor will run continuously until the wine cooler
reaches a cool enough temperature.
o During this period of time, you should try not to open the door frequently or place bottles inside
of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the
appliance or reconnecting it to your mains supply.
Switching on the appliance and setting the temperature
Switching between Celsius and Fahrenheit
To alter what the temperature displays are showing, press the for 5 seconds.