Herunterladen Inhalt Inhalt Diese Seite drucken

Handle Installation; Electronic Control - Cavist Cavist24 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15

HANDLE INSTALLATION

To install the door handle follow the below steps:
1. Open the door of the appliance and move the door gasket
slightly to one side so that you can see two designated holes
for handle installation
2. Install the handle tightly as shown in the diagram above with
the two screws provided.
3. Ensure the door gasket falls back into place and that the
door opens and closes correctly.
IV. OPERATION OF WINE COOLER
Your wine cooler has an electric temperature control on the front of the unit. You may program of
your wine cooler at any setting you desire. The temperature range varies from 11 to 18 degrees.
When initially turned on, the display will show the ambient temperature and then the internal
cabinet temperature. The zone temperature may have a difference of 3
depending on loading and ambient conditions. It is recommended you install the wine cooler in a
place where the ambient temperature is between 23º-26ºC/72º-78ºF. If the ambient temperature is
outside this range, the performance of the unit may be affected. Placing your unit in extreme cold
or hot conditions may cause interior temperatures fluctuation.
Recommended temperatures for chilling wine:
Red wines: 14-18°C/57-65°F
White wines: 9-14°C/49-58°F
Rosé wines: 10-11°C/51-53°F

ELECTRONIC CONTROL

You can display the temperature in either Fahrenheit or Celsius by pressing the °F/°C button.
You may change the temperature as you wish by pressing the UP or DOWN buttons on the
control panel. The set temperature will increase by 1ºF or 1ºC for each depression of the UP
button. The temperature will decrease by 1ºF or 1ºC for each depression of the DOWN button.
Once you have set the desired temperature, the display will flash for 5 seconds and then revert
to the internal cabinet temperature.
You can turn the interior light ON or OFF by pressing the
When you press both UP and DOWN buttons for at least (3) three seconds, you get the
temperature readout either in Fahrenheit or Celsius.
(5 ) from setting
button.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis