Cavist CAVISTXV3 Gebrauchsanweisung Seite 7

Positioning & Installation
This appliance can be installed as a freestanding or a built in unit. The clearances shown in the
•
below drawing should be followed for both types of installation.
Avoid damaging the product during installation, positioning of the appliance requires two
•
people in order to avoid injuries or damage to the appliance.
Your appliance should not be located in direct sunlight or exposed to continuous heat or
•
extremes of temperature (e.g. next to a radiator or boiler). If this is not feasible, then you should
install an insulation plate between the appliance and the adjacent heat source.
You should check whether there is an electrical socket available, which will be accessible after
•
your appliance is installed.
Place the appliance flatly and firmly on a solid base. The appliance is fitted with adjustable feet,
•
which should be used to level the appliance.
Be sure to leave enough space for the opening of the door, to avoid damage to the appliance
•
or personal injury
If installing as a built in unit the aperture size has to be a minimum of (H)875 x (W)300 x
•
(D)590mm. The depth dimensions in particular must be observed.
Important: The vent at the base of the appliance is for ventilation. Nothing should be placed in
front of this vent; otherwise your wine cabinet may not operate properly.
A decorative plinth can be fitted to the front of the base vent as long as the cut out shown in the
•
diagram below is made in the plinth. This cut out is required whether the vent is removed or not.